Table of Contents
Advertisement
Control functions
1. 2-up adjusting block
TIP
Be sure to make this adjustment when
there is no load (rider or cargo) on the
snowmobile.
Use the special tools included in the own-
er's tool kit to make the adjustment.
1.
Insert the special tools into the 2-up ad-
justing block as shown.
1
1. 2-up position (rider and passenger)
2. Solo rider position
3. Special tool
4. Lock pin
2.
Pull the lock pin and turn the special
tools to change the block position.
3.
Release the lock pin.
4.
Remove the special tools from the 2-up
adjusting block.
28
2
4
3
ESU11036
Adjusting the control rods (PZ5NT)
EWS00771
WARNING
The left and right adjusting nuts must be
set to the same position. Uneven settings
can cause poor handling and loss of sta-
bility.
The weight transfer can be adjusted by turn-
ing the adjusting nuts on the control rods.
1.
Loosen the locknut while holding the ad-
justing nut.
1. Locknut
2. Control rod adjusting nut
2.
To increase weight transfer, turn the ad-
justing nut in direction (a), and to de-
crease weight transfer, turn it in direction
(b). WARNING! Never adjust the con-
trol rods beyond the maximum set-
Advertisement
Table of Contents
