Adding Staples (Optional) - Panasonic DP-6530 Operating Instructions Manual

5. ADDING STAPLES (OPTIONAL)

1 When the staple cartridge runs out of staples, if the optional finisher is installed, the following message
appears:
Set staple cartridge
2
Add staples to the cartridge according to the procedure below.
3
1 Open the front cover of the finisher.
4
5
2 Lower the blue lever in the stapler and slide out
6
the staple cartridge.
- The stapler unit has moved to its specified position.
- Do not move the stapler unit while performing the above
procedure, or it will be broken.
7
8
3
Remove the empty staple case upward from the
staple cartridge.
9
10
11
4 Push in a new staple case into the staple cartridge
completely inside until a click is heard.
- Do not remove the seal holding the staples until the staple
case is set in the cartridge.
12
7-20
WHEN THE GRAPHIC SYMBOLS FLASH ON THE TOUCH PANEL
Finisher (DA-FS810/FS815)