6. REMOVING JAMMED STAPLES (OPTIONAL)
When copies have not been stapled in the staple mode, the following message may be shown on the
1
display:
Examine stapler
This means that staples have become jammed. Remove them as described below.
2
3
1
Perform steps 1 to 2 on page 7-21.
4
2
Holding the knob, lower part
5
Caution
Do not touch the stapling area.
The stapler could injure you.
6
7
3
Remove any jammed staples using your fingertip
or something sharp.
8
9
4
Holding the knob, return part
position.
10
11
12
7-24
WHEN THE GRAPHIC SYMBOLS FLASH ON THE TOUCH PANEL
Finisher
.
A
to its original
A
Stapling area
A
A