Table of Contents
Advertisement
18 | Drystar 5301, Drystar 5302 | Advanced Operation (key-operator mode)
Viewing general image quality information
1. On the Show settings menu, press the Down key four times, followed by
the Confirm key to select 'Image quality'.
The following screen will appear:
2 <Modality name>
3 <Modality name>
2. Press the Confirm key to select 'General settings'.
The following screen appears:
3. Do one of the following:
• If you select 'Def.film calib.' the general image quality settings are
• If you select 'Def. densitometer', the default densitometer type is
4. The general image quality settings are displayed:
The following information is displayed:
• whether the automatic film calibration setting is set to OFF or ON,
• the number of film packs determining the automatic film calibration
• the maximum density result value (e.g. '3.20') of the last successful
Proceed with step 6.
5. The default densitometer type is displayed:
6. Press the Confirm key to return to step 2, then press the Escape key to
return to the Image quality menu (see step 1).
7. In the Image quality menu, press the Escape key to return to the Show
settings menu.
Related Links
Accessing the Show settings menu
2830F EN 20210520 0952
displayed. Proceed with step 4.
displayed. Proceed with step 5.
interval (e.g. every '05' film packs) (only if film calibration setting is
set to ON),
film calibration for the upper and lower input tray.
on page 14
Advertisement
Table of Contents
