Table of Contents
Advertisement
32 | Drystar 5301, Drystar 5302 | Advanced Operation (key-operator mode)
Example 2: if the IP address is 120.0.120.120, then the data entry should
be as follows:
4. Press the Confirm key to store the data, or the Escape key to quit the
procedure without any changes.
Related Links
Accessing the Change settings menu
Data entry
Changing the netmask
1. On the Change settings menu, press the Down key three times, followed by
the Confirm key to select 'Network (DICOM)'.
The 'Network (DICOM)' screen is displayed:
5 Netmask
6 Router IP-address
7 Remove modality
8 Add modality
2. On the 'Network (DICOM)' screen, press the Down key four times,
followed by the Confirm key to select 'Netmask'.
The 'Netmask' screen is displayed:
If the netmask has already been assigned, it will be shown on the display.
3. Enter the netmask by means of the arrow keys.
Example: if the netmask is 250.250.250.0, then the data entry should be
as follows:
2830F EN 20210520 0952
on page 12
250.250.250.250
Note: When no DHCP server is available and when the
subnet mask of the printer has never been set, the printer
250.250.250.250
subnet mask will be set to the APIPA address 255.255.0.0.
Note: Note that blank spaces will be ignored (see example).
250.250.250. 0
250.250.250. 0
on page 23
Advertisement
Table of Contents
