AGFA Drystar 5301 Reference Manual page 118

118 | Drystar 5301, Drystar 5302 | Problem solving
Remove and re-insert
Remove and re-insert
film pack -including
film pack -including
protective sheet-
protective sheet-
properly. follow
properly. follow
loading instructions
loading instructions
2. To continue with the current (not identified) film pack, press the Confirm
button.
The following message is displayed:
Please INSERT
Please INSERT
CURRENT FILM PACK or
CURRENT FILM PACK or
call service.
call service.
3. Press the Confirm button.
• If the "Overrule RF-tag Reading" Setting is active, the following
• If the "Overrule RF-tag Reading" Setting is not activated, the following
4. Press the Confirm key again to resume printing using a limited Maximum
Density.
2830F EN 20210520 0952
Note: If you wish, you can try again to re-insert the current
or an other film pack. Press the Unlock button to initiate the
loading sequence. If you re-insert a film pack, the printer
will perform the check-sequence.
message is displayed:
OVERRULE
OVERRULE
IDENTIFICATION CODE IDENTIFICATION CODE
IS ACTIVE IS ACTIVE
Dmax is limited due
Dmax is limited due
to safety reasons to safety reasons
message will be displayed:
Re-enable printing
Re-enable printing
by inserting correct by inserting correct
film media pack. film media pack.
Note: In this case, press the Confirm key to initiate the
loading procedure again or call your local service
organization to enable the "Overrule RF-tag Reading"
Setting.