Table of Contents
Advertisement
188 | DR 600 | Ceiling Suspension
Do not use the remote control after starting a digital tomosynthesis workflow
or a full leg full spine workflow, until the complete sequence of exposure has
ended.
A configuration can contain one of both remote controls or a combination of
both remote controls.
When more than one button is pressed, the movement is stopped and a
message is displayed. Operation can be resumed after all buttons have been
released for 200 msec.
While more than one remote control can be linked to a system, only one
remote control can be used at the same time.
Related Links
Charging the battery of the remote control
No movement when using remote control
3261K EN 20210708 0808
CAUTION:
When no movement of the system can be activated using the
remote control and no error is shown, the X-ray generator may
need to be restarted to restore communication between the
remote control and the system.
Note: The speed of the movements controlled by the remote
control is slower than movements controlled by the automatic
positioning button.
on page 25
on page 260
Advertisement
Table of Contents
