Preparing Replacement Product Bags - Cornelius HELIX Operator's Manual

Preparing Replacement Product Bags

© 2012-2014,Cornelius Inc. All Rights Reserved
!
WARNING:
Syrup bags must not be connected or prepared until all ingredient lines have
been sanitized and the unit has been pre-chilled to operating temperature (32-
40° F). Refer to the System Sanitation section on page 13.
The Ingredient Status Screen is used to prepare the bags. The Ingredient Status
Screen shows the location for each syrup bag in the cabinet. The level indicators
show the amount of product in each bag. To prepare the system after replacing a
product bag, perform the procedure in Table 9.
Step
From the Main Screen, select the Ingredient Status Screen (Figure 15)
1
by pressing the Menu button, shown in Figure 1 on page 10.
Place each bag/tray in its appropriate location, making sure that the bag
2
connector is fully seated onto the stem in the back of the cabinet.
Select all ingredients that have been replaced and press the Play button
3
(See Figure 16 and Figure 17).
4 Follow the on-screen instructions to finish preparing the bags in the unit.
NOTE: The bag should engage the fitting on the back wall. If product is leak-
ing out, the connection did not seal and the bag should be reinserted.
- 19 -
Helix Operator's Manual
Table 9.
Action
Figure 15.
Publication Number: 621058497OPR