Table of Contents
Advertisement
I disabled DHCP and assigned a correct IP configuration, but I cannot access the
•
web front-end.
Reset the MECip-Sec and try again. More information about changing the IP network
configuration can be found in chapter 4.5.2.
I try to access the web front-end but I'm not successful. What can I do?
•
Make sure the web front-end is not deactivated and the URL bar entry matches the
correct IP address together with the right HTTP port or use the MAC address in exactly
the way as explained (chapter 6.2.3). Then refresh the browser and try again. Or check
IP configuration via TP by ETS.
Is it possible to reach the web front-end when the device is in boot mode?
•
Yes, it is. The web front-end is accessible (chapter 6.5). When boot mode is active, the
web front-end looks like illustrated in
Update tab must be used or, after 10 min, it will be switched off automatically.
Is it possible to do a Reset during the device is in boot mode?
•
No. LED 2 Bus State KNX TP will light up red when holding the Function button.
How can I find out the actual IP address of my MECip-Sec?
•
In the web front-end, the Device Info tab shows the actual IP address.
When ETS can connect to MECip-Sec via IP, the IP address is contained in the list of
Discovered Interfaces.
In Windows, with a right click on the network device the properties window can be
opened. MAC address, IP address, HTTP port, serial number and version of firmware
(application software version) can be found here.
How can I reach the web front-end in case I don´t know IP address and MAC
•
address?
When MECip-Sec cannot be accessed via the device list in the Windows network
explorer (after refreshing the window), the actual IP address must be found at first. Use
the properties window of the network device in Windows or the list of Discovered
Interfaces in ETS to do that.
FAQ
Figure
13. To exit boot mode the web front-end
MECip
SECURE
- 48 -
Advertisement
Table of Contents
