Table of Contents
Advertisement
1.6
Important Notes
It is recommended to participate the standardized courses of a KNX-certified training center
before installing, programming, and commissioning a KNX system. Here, the participant gains
the necessary knowledge and skills, also required for troubleshooting, by practical exercises.
Please read this chapter carefully before first use and installation:
1.6.1
Installation and Commissioning
• In the case of damage (at storage, transport) no repairs may be carried out by
unauthorized persons
• After connection to the KNX bus system, the device works with its default settings
Warning: Do not connect to 230 V. The device is supplied by the KNX bus and does not
•
require any additional external power supply
• The device may only be installed and put into operation by a qualified electrician or
authorized person
• For planning and construction of electric installations the appropriate specifications,
guidelines and regulations in force of the respective country have to be complied
• For configuring, use the ETS (or ETS Inside)
1.6.2
Mounting and Safety
• For mounting use an appropriate equipment according to IEC60715
• Installation on a 35 mm DIN rail (TH35)
• Connect the KNX bus line as for common KNX bus connections with a KNX bus cable, to be
stripped and plugged into a KNX TP connector
• Do not damage electrical insulations during connecting
• Installation only in dry locations
1.6.3
Maintenance
• Accessibility of the device for operation and visual inspection must be provided
• The housing must not be opened
• Protect the device from moisture, dirt and damage
• The device needs no maintenance
• If necessary, the device can be cleaned with a dry cloth
Product Description
MECip
SECURE
- 11 -
Advertisement
Table of Contents
