Running Mail With The Di900™/Di950™ Inserting System Interface; Inserting System Interface - Pitney Bowes SendPro P Series User Manual

Running mail
Selecting the Residual Rate Surcharge
1. Ensure that the appropriate job is open and selected on the Run Mail screen.
2. Ensure that the Residual Rates Surcharge is set to Yes. If necessary, select Residual Rate
Surcharge in the Mail Information list box to toggle between Yes and No.
3. Select the carrier, class and special services you want to use to process the mail.
4. Select Billing Class in the Mail Information list box.
a. Select the class of postage you want to use to bill your customer.
b. Select OK.
5. Select Start to begin running mail.
Running Mail with the DI900™/DI950™ Inserting System
Interface
The inserting system interface enables communication between DI900™/DI950™ FastPac® inserting
systems and SendPro P systems via an Ethernet/LAN connection. When the inserting interface is in
place, the inserter feeds mailpieces onto the mailing and shipping system feed deck for metering.
Note:
Mailpieces must be sealed by the inserter.
l
On SendPro P1000 systems, all mailpieces in a job must be identical.
l
The inserter sends start and stop signals to the mailing and shipping system. The mailing and
l
shipping system can send error messages back to the inserter to stop feeding.
If the mailing and shipping system is overcome with mail, it can pause the inserter to prevent it
l
from producing any additional mailpieces, process the mailpieces on the feeder, then signal the
inserter to resume once it has caught up.
When the mailing system is in maintenance mode, it will pause the inserter, then signal the
l
inserter to resume once maintenance is complete.
For more information about the DI900/DI950 FastPac inserting system, refer to the refer to the
documentation provided with the inserter.
Pitney Bowes User Guide April 2022 68