Table of Contents
Advertisement
H35U-NG / LP AND H35S-NG / LP
maintenance
Fan Maintenance
WARNING: Electrical Grounding Instructions
This appliance is equipped with a three pronged (grounding) plug for
your protection against shock hazard and should be plugged directly
into a properly grounded three-prong receptacle. Do not cut or remove
the grounding prong from this plug.
Figure 9
Removing the Fan
1. Unplug or disconnect power source to stove.
2. Reverse steps 7 to 10 from "Installing the Optional Fan" instructions
above.
Servicing the Thermodisc
To replace or service the fan thermodisc (temperature switch), use the
following steps:
1. Unplug or disconnect power source to stove.
2. Remove two screws from the lower left and lower right areas of the
back cover panel.
Figure 1
Figure 11
46
920-450
Figure 10
Figure 2
Figure 12
3. Lift the back cover panel up and pivot out away from the
unit. Take care note to pull on the wires attached to the
back cover panel.
4.The thermodisc can now be accessed on the back of the
firebox behind the air intake tube. (Image 14)
NOTE: When servicing the thermodisc ensure you do not
damage the air intake flex tubes.
Hampton® H35U Direct Vent Freestanding Gas Stove
2
Figure 3
Figure 13
Figure 14
Figure 4
10.20.21
Advertisement
Table of Contents
