Table of Contents
Advertisement
installation
4) Place Rear Log A)02-43 on the two pins on
the rear log support.
Pins on Rear Log Support
5) Place the Middle Left Log B)02-56 on the
two pins as shown.
B)02-56
6) Sprinkle some lava rock just in front of B)
02-56 on the burner holes.
B)02-56
lava rock
7) Place Front Left Log C)02-44 onto the 2
front pins as shown.
C)02-44
38
8) Place the Left Top Log D)02-46 on the pin
on Log B)02-56 and on top of the cutout
on Log A)02-43.
A)02-43
D)02-46
C)02-44
9) Place Front Right Log E)02-45 on the two
pins as shown.
10) Place the lava rock in the area between the
left and right logs, leaving a space in the
middle for log (F) 02-47.
Separate platinum embers and place on and
around the lava rock. Avoid stacking platinum
embers.
11) Place the notch in Center Log F)02-47 over
Log E)02-45 and across the cutout on Log
A)02-43.
A)02-43
B)02-56
Cutout
Pin
E)02-45
A)02-43
E)02-45
Notch
Cutout
12) Position notch in Front Right Log G)02-48
on Log F)02-47 and push the bottom right
edge against the bracket on the burner tray.
Notch
G)02-48
Side View
Bracket
The bottom right edge of Log G)02-48 must
sit snugly against the bracket. (Front Log
02-45 has been removed so that the bracket
can be seen.)
13) Test fire to ensure proper light off (make
sure flame flows smoothly from one end
of burner to the other. If there is any flame
hesitation, check that area for any blockage
of the burner port.
B)02-56
C)02-44
Double Door Removal
1) Remove the right door by unfastening the
2 right hinges (2 screws per hinge).
Repeat for the left door.
Hampton® H35U Direct Vent Freestanding Gas Stove
A)02-43
E)02-45
A)02-43
E)02-45
Advertisement
Table of Contents
