Table of Contents
Advertisement
Important Message
SAVE THESE INSTRUCTIONS
The Direct Vent Freestanding Gas Stove must be
installed in accordance with these instructions.
Carefully read all the instructions in this manual first.
Consult the building authority having jurisdiction to
determine the need for a permit prior to starting
the installation.
Note: Failure to follow the instructions could
cause a malfunction of the heater which
could result in death, serious bodily
injury, and/or property damage. Failure
to follow these instructions may also
void your fire insurance and/or warranty.
Note: These instructions take precedence over
Simpson Dura-Vent instructions.
Specifications
Fuels:
H35U-NG is approved for use with natural
gas.
H35U-LP is approved for use with
liquefied petroleum gases (propane).
Electrical: 120V A.C. system.
Circulation Fan: Variable speed, 125/75.
Log Sets: Ceramic fibre, 7 per set.
Vent System: Coaxial (6-5/8" outer / 4" inner liner)
rigid flue and termination cap.
The efficiency rating of the appliance is a
product thermal efficiency rating determined
under continuous operating conditions and was
determined independent of any installed system.
Hampton® H35U Direct Vent Freestanding Gas Stove
Information for Mobile /
Manufactured Homes After First
Sale
This Hampton
product has been tested and listed by
®
ITS Testing Services as a Direct Vent Wall Furnace
to ANSI Z21.88.
This Direct Vent System Appliance must be
installed in accordance with the manufacturer's
installation instructions and the Manufactured Home
Construction and Safety Standard, Title 24 CFR,
Part 3280, or the current Standard of Fire Safety
Criteria for Manufactured Home Installations,
Sites, and Communities ANSI/NFPA 501A, and
with CAN/CSA Z240-MH Mobile Home Standard
in Canada.
This appliance installation must comply with the
manufacturer's installation instructions and local
codes, if any. In the absence of local codes follow
the current National Fuel Gas Code, ANSI Z223.1
and the current National Electrical Code ANSI/NFPA
70 in the U.S.A., and the current CAN/CSA B149.1
Gas Installation Code and the current Canadian
Electrical Code CSA C22.1 in Canada.
This Hampton
Mobile/Manufactured Home
®
Listed appliance comes factory equipped
with a means to secure the unit.
This Hampton
Mobile/Manufactured Home
®
listed appliance comes equipped with a
dedicated #8 ground lug to which an 18
gauge copper wire from the steel chassis
ground must be attached.
This appliance may only be installed
in an aftermarket permanently located,
manufactured (USA only )or mobile
home, where not prohibited by local
codes.
This appliance is only for use with the type
of gas indicated on the rating plate. This
appliance is not convertible for use with
other gases, unless a certified kit is used.
installation
11
Advertisement
Table of Contents
