Editing An Effect; Effect Programs And Chains; Type And Chain Configuration; Selecting The Effect Type And Chain - Korg ToneWorks PXR4 Owner's Manual

to "MASTER" (master effect).
Select an effect program.
2
Press the [EFFECT/TUNER] key to enter Effect mode,
and turn the dial to select an effect program.
Set the return level from the master effect to LR.
3
Press the [CURSOR] right key to display the
"EffRetLv" page, and use the dial to adjust the setting.
You can hold down the [SHIFT] key and press the [CURSOR]
right key to jump from one item to the next.
Set the return balance from the master effect to LR.
4
Press the [CURSOR] right key to display the "EffRt-
Bal" page, and use the dial to adjust the setting.
Use the send level to adjust the depth of the effect.
5
Enter Mixer mode, and adjust the send level while
you listen to the L/R playback from [OUTPUT]
( p.35).
Using a final effect
One stereo in/out final effect is built-in. For example you
can use a dynamics-type effect (such as a limiter) to make
the overall level more consistent.
Select the final effect.
1
Hold down the [SHIFT] key and press the [EFFECT/
TUNER] key to switch the "EFFECT ASSIGN" display
to "FINAL" (final effect).
Select an effect program.
2
Press the [EFFECT/TUNER] key to enter Effect mode,
and turn the dial to select an effect program.
Play back the song to listen to the L/R output, and
hear the result of the selected effect.

2. Editing an effect

You can edit the effect program selected for each effect
type.
If you move to another mode or turn off the power without
saving the edited effect, your settings will be lost. If you will
want to use the edited effect again, you must perform the
"Save effect" operation.

Effect programs and chains

The combination of effect modules that can be used simul-
taneously and the order of their connection is referred to
as a "chain." The PXR4 provides eight chains that are suit-
able for various purposes: [CHAIN1]–[CHAIN8]. The fac-
tory preset settings contain 100 effect programs, each of
which consists of one of these chains.
To edit an effect program, start with one of these factory-
preset effect programs.
Type and chain configuration
The chain configurations for each type are as follows.
[GUITAR] monaural-in – monaural-out
[CHAIN 1] This chain is suitable for electric guitar.
DRIVE CABI NR
[CHAIN 2] This chain is suitable for a variety of input
sources, such as mic, electric bass, or synthesizer.
LIMITER 4BAND EQ GATE
[CHAIN 3] This chain is suitable for electric bass.
BASS DRIVE BASS CABI NR
Operation
MOD DELAY
MOD DELAY
MOD DELAY
37