Using Marks To Change The Time Location; Registering A Mark; Changing The Time Location In Order Of The Mark Numbers; Changing The Time Location In Order Of The Locations Registered To Each Mark - Korg ToneWorks PXR4 Owner's Manual

keys to change the blinking unit. Moving toward the
right will switch screens, allowing you to move in
smaller units.
If "LocMoni" ( p.63) is turned "On," you will be able to lis-
ten to the sound while you change the time location.
Press the [EXIT] key to return to normal Locate
3
mode.
When you press the [EXIT] key, you will return to the
initial counter mode. To move from the middle of the
song to the beginning, press the [REW] key.

3. Using Marks to change the time location

You can register a specific time location as a "mark," and
then move instantly to the registered time location. As a
convenience for track editing, you can also register marks
for the desired InTime, OutTime, ToTime, and EndTime,
and select these marks when editing.
You can use marks to move even while the song is playing.

Registering a mark

In any mode, you can use the following procedure to reg-
ister a mark.
Move to the time location where you want to register
1
a mark.
Press the [STORE MARK] key, and the current time
2
location will be saved as a new mark.
The number of the registered mark and the time loca-
tion will be displayed for a certain length of time.
You can register a mark in the same way by pressing
the [STORE MARK] key even while a song is playing
or being recorded.
The last time location in the song is automatically registered
in the mark number "End." This is useful when you want to
move to the end of the song.
To save the marks that you registered in a song, press the
[STOP] key to save the song. If you turn off the power with-
out saving the song, the registered marks will not be saved.
( p.14)
Changing the time location in order of the mark num-
bers
Here's how to change the current time location in the
order of the registered mark numbers.
Press the [MARK] key to enter Mark mode.
1
When you use the [MARK] key to enter Mark mode,
the "Mark icon" will blink, and "–" will indicate the
value. At this time the current time location has not
yet been moved.
Move from one mark to the next.
2
When you turn the dial, the value display will show
the registered mark numbers and their time locations.
At the same time, the current time location will
change accordingly. Press the [EXIT] key to return to
Locate mode.
Changing the time location in order of the locations reg-
istered to each mark
Here's how to change the current time location in the
order of the time location of each registered mark.
Move to the beginning of the song.
1
Hold down the [SHIFT] key and press the [FF] key.
The value indicator will show "00."
Mark number "00" is pre-registered as the beginning of the
Operation
33