Korg ToneWorks PXR4 Owner's Manual page 87

Set the counter display to "FreeTime" and check the
amount of recordable time. ( p.56)
Is the bounce setting ("BOUNCE") appropriate?
( p.29)
If the bounce setting ("BOUNCE") is set to "CONV,"
the recording will be created as a new song. ( p.51)
Can't record two tracks simultaneously
The "EFFECT ASSIGN" (effect insert location) may
have been set to "GUITAR."
If this is set to "GUITAR," only one track can be
recorded simultaneously.
Input sound or recorded sound contains noise or distor-
tion
Is the [TRIM] knob raised to an appropriate level?
If the [TRIM] setting is too high the sound will distort;
if it is too low, noise will be heard. ( p.18)
If the effect input is distorted, make the following
adjustments.
Guitar/insert effect: Hold down the [SHIFT] key and
press the [DISPLAY] key, and select the "PRE" setting
for "DISPLAY." Then use [TRIM] etc. to adjust the
input volume as high as possible without allowing
"CLIP" to light in the level meter.
Master effect: Adjust the faders and send level so that
"CLIP" for the master L/R track does not light.
Final effect: Adjust the faders so that "CLIP" does not
light for the master L/R track.
If the effect output is distorted, make the following
adjustments.
Guitar/insert effect: Adjust the effect parameters and
[TRIM] while listening to the sound.
Master/final effect: Adjust the effect parameters so
that "CLIP" for the master L/R track does not light.
Effect does not apply
Tuner mode may have been selected.
The effect will be bypassed (off) when the tuner is
selected.
Is the master volume of the effect program set to "0"
or close to "0"?
Press the [EFFECT] key, then press the [CURSOR]
right key several times to display "ProgMVol," and
raise the volume setting.
Is the [TRIM] knob raised to an appropriate level?
If the [TRIM] setting is too low, the effect may not be
applied in some cases.
Guitar/insert effect does not apply
Is the effect insert location appropriate?
Hold down the [SHIFT] key and press the [EFFECT]
key, and set "EFFECT ASSIGN" to "GUITAR" or
"INSERT." ( p.35)
It is not possible to use a guitar/insert effect on a play-
back track.
Master effect does not apply
Is the effect insert location correct?
Hold down the [SHIFT] key and press the [EFFECT]
key, and set "EFFECT ASSIGN" to "MASTER."
( p.35)
Is the send level from each track set to "0"or close to
"0"?
Press the [MIXER] key, and use the [CURSOR] keys to
raise the "Send-L" and "Send-R" send levels.
Appendices
85