Configuring The Computer's Serial Interface Settings - Smart Technologies SMART Board 6000S Series Installation And Maintenance Manual

Appendix C Managing the SMART Board 6000S (V3) display using RS-232
Important
Use only a standard RS-232 cable. Do not use a null modem cable. Null modem cables typically have
ends of the same type.
Tip
SMART also offers SMART Remote Management cloud-based device-management software, which
you can use to manage SMART Board interactive displays with iQ and devices running Windows,
™
Chrome OS, Android
Remote Management.

Configuring the computer's serial interface settings

Configure the computer's serial interface before sending commands to the display.
To configure the computer's serial interface
1. Turn on the display.
2. Turn on the computer, and then start the serial communications program or terminal emulation
program.
3. Activate local echo.
4. Configure the serial interface settings using the following values, and then press ENTER.
Baud rate
Data length
Parity bit
Stop bit
A command prompt (>) appears on the following line, and the display can now accept commands
from the computer.
Note
If no message appears or an error message appears, the serial interface isn't configured
correctly. Repeat steps 3 and 4.
smarttech.com/kb/171414
™
, and iOS operating systems. For more information, see SMART
19200
8
None
1
78