Glass Gasket; Glass Replacement; Removing Valve Assembly; Installing Valve Assembly - Regency C34 Classic Owners & Installation Manual

maintenance
|
46

GLASS GASKET

If the front glass requires replacement use (Part
# 490-548).
GLASS
REPLACEMENT
Your CLASSIC stove is supplied with high tem-
perature, 5 mm Neoceram ceramic glass that
will withstand the highest heat that your unit will
produce. In the event that you break your glass by
impact, purchase your replacement glass from an
authorized Regency dealer only.
®
REMOVING VALVE
ASSEMBLY
1. Shut off gas and electrical supply.
2. If optional fan is installed, disconnect power
source to stove.
3. Remove access panel.
a ) Fr o n t p a n e l o n p e d e s t a l m o d e l .
See Diagram 1.
b) Panel from bottom of leg shield.
See Diagram 2.
Note: Access panel only has to be loosened
to be taken out.
4. Remove valve cover plate by removing two (2)
screws.
5. Disconnect receiver wire.
6. Remove cover plate by removing 4 screws
(Pedestal option only).
7. Disconnect gas line to stove.
46 |
Regency ® CLASSIC™ C34-11 Direct Vent Freestanding Gas Stove
Cover Plate
Access Panel
Diagram 1
Diagram 2
8. Disconnect 3/8" NPT pipe from 90
valve.
9. Disconnect the two (2) switch wires from valve.
10. Disconnect three (3) fan wire from DC sparker.
11. Remove orifice.
12. Loosen four (4) Phillips head M5 valve mounting
screws from underside of firebox. Drop valve
assembly down.
To remove valve from valve assembly, continue.
13. Remove two (2) thermopile wires.
14. Remove thermocouple with a 9 mm (metric)
Valve Cover
wrench.
Plate
15. Remove pilot nut with an 11 mm wrench.
16. Remove valve to orifice nut with a 13/16" wrench.
17. Remove inlet pipe with pipe wrench. Note
orientation of 90o elbow.
18. Remove two (2) phillips head M5 screws on
each side of the valve.
19. Remove valve and remove gas out 90o brass
fitting. Note orientation of fitting.
See Diagram in "Optional Fan Installation"
section for more detail.
INSTALLING
VALVE ASSEMBLY
1. To install a new valve assembly, reverse instruc-
tions for removing valve. See assembly steps
1-10.
2. Check for leaks and manifold pressure. See
Gas Pressure Test instructions.
3. To reinstall valve, reverse instructions for remov-
ing valve assembly, steps 11-17.
o elbow on