DOOR INSTALLATION
Door Handle Assembly
1. Door will be packaged with door retaining clip facing inwards (Diagram 1).
2. Unscrew and turn the door retaining clip outwards, then re-tighten the
screw (Diagram 2).
920-076
DOOR INSTALLATION
Diagram 1
Diagram 2
Safety Screen Installation / Removal
3. Install slotted brackets (found in the manual pack) to the back of the door
with two (2) screws on each side as shown in Diagram 3.
Before
4. Attach door handle to door by installing the handle through the hole on
the left upper corner (Diagram 4). Position the handle in the 8 O-clock
positions, then tighten with 14mm (9/16") wrench.
5. Place the door onto the door hinges. Put the hinge cover caps on top of
hinges to complete the door (Diagram 5).
Diagram 5
Note: The bottom of the door may scrape the ash lip. In this case place the
spacers provided on the door hinges of the unit before placing the door.
Regency
CLASSIC™ C34-11 Direct Vent Freestanding Gas Stove
®
installation
C34E-11
After
Diagram 3
Diagram 4
|
37
03.01.19
|
37