Blower Removal - Toro Groundsmaster 200 Series Installation Instructions Manual

3. Disconnect hydraulic line quick couplers.
4. Remove (2) hair pin cotters securing tie rods to frame.
5. Remove (2) welded mounting pins and hair pin cotters
securing hopper to frame. Remove hopper from frame.
6. Disconnect wire harness from switch on hopper frame
or seat and remove from traction unit. Keep harness
with hopper.
Note: Hopper frame is heavy. Support frame when
removing or have a helper assist you.
7. Remove disconnect pin securing rear of frame to
machine. Slide frame off machine.
8. To prevent contamination of hydraulic lines, connect
hopper lines together.
9. Insert dust caps over hydraulic fittings on machine.

Blower Removal

1. Shut engine off, disengage and latch idler, unlatch and
open belt cover and lift belt off spindle pulley. Close
cover. Remove (2) knobs securing blower to mounting
brackets and remove blower, belt and chute
2. Reverse procedure to reinstall blower assembly.
Caution
When blower is removed, NEVER operate
without deflector in place.
17