Install Decals - Toro Groundsmaster 200 Series Installation Instructions Manual

6
3
1
Figure 21
1. Wide shield
2. Long flat
3. Narrow shield

Install Decals

1. Install valve operation decal to right side of seat frame
and caution decal to left side of seat frame.
Mount Wheel Weight
1. Measure depth of wheel rim. This is achieved by
measuring the distance from hole to outside edge of
rim.
2. Add 3–7/8" to measurement attained. This becomes
dimension "A" in figure 22.
3. Thread a hex nut onto each threaded rod to "A"
dimension.
4. Insert threaded rods through 2 opposite holes in rim and
secure in place with 1/2" Iockwashers and hex nuts
(Fig. 22).
2
1
Figure 22
1. Wheel weight
2
5
2
4
4. Narrow shield
5. Short flat
6. Cut off 1–1/2"
2. Threaded rod
15
5. Place wheel weight over ends of threaded rods and
secure in place with flatwashers, Iockwashers and hex
nuts (Fig. 22). Do not overtighten hex nuts or damage to
the plastic housing of the weight may occur.
Note: If there is excess thread protruding from nuts or
inside of wheel, cut it off with a hacksaw. Threaded rod
must not contact any parts of the machine when wheel is
rotating.
Important
If mounting Hopper Kit on a 52" Side
Discharge Deck, (2) Rear Weight Kits, Part No. 24–5780
and a Bracket kit, Part No. 92–9670 must be installed on
left side of traction unit to meet ANSI requirements. Refer
to traction Unit Operator's Manual for additional weight
requirements.