Connect Hydraulic Hoses - Toro Groundsmaster 200 Series Installation Instructions Manual

Figure 11
1. Rear hopper mounting
bracket
13. Mount bottom of bracket to frame with (2)
1/2–13x1–1/2" Ig. capscrews, mounting strap, 1/2
flatwashers and locknuts. Strap to be positioned
between frame and bracket.
14. From rear of machine, slide front of hopper frame onto
side mounting bracket pins and rear of frame over rear
bracket pin.
15. Secure rear of frame to bracket pin with disconnect pin
(Fig. 12).
Figure 12
1. Disconnect pin
16. Install short and long welded mounting pins through
arm assembly and main lift arm assembly (Fig. 13).
Secure with 1/4–20 x 3/4" Ig. self tapping screws.
1
2. Straps (behind bracket)
1
12
1
2
4
Figure 13
1. Arm assembly
2. Main lift arm assembly

Connect Hydraulic Hoses

1. Slide loop end of dust plug over end of hydraulic hose
from bottom valve fitting. Insert female coupler thru
bottom hole in coupler bracket and secure with
retaining ring.
2. Secure hose assembly to female coupler (Fig. 14).
3. Slide loop end of dust cap (Fig. 14) over end of
hydraulic hose coming from top valve fitting. Install
male nipple to hose end.
4. Insert end of hose thru top hole in coupler bracket
(Fig. 14). Secure hose assembly to bracket with
retaining ring.
5. Connect appropriate hydraulic hose from hopper
assembly to hoses installed to coupler bracket.
4
3
6
Figure 14
1. Top hydraulic hose
2. Coupler bracket
3. Retaining ring
3
3. Short pin (on left side)
4. Long pin (on right side)
2
1
3
5
4. Dust cap
5. Bottom hydraulic hose
6. Dust plug