Maintenance; General Practices - Toro Groundsmaster 200 Series Installation Instructions Manual

Maintenance

Adjusting Rear Cover Latch
1. Adjust latch assembly (Fig. 23) up or down if cover
does not seal properly or if cover does not latch when
operating.
1
Figure 23
1. Latch assembly
Caution
Never work on hopper unless it is in the
lowered position.

General Practices

1. Keep unit clean, checking that engine is free of dirt and
chaff. Make sure all fasteners are tight. Check
deflectors, baffles and shields for wear and replace as
needed.
2. Clean grass clippings from hopper, chute, blower and
cutting unit after each use. Wash underside of cutting
unit daily with hose. An excessive buildup of clippings
will impair collection system performance.
3. Refer to Cutting Unit and Traction Unit Operator's
Manuals for service requirements of each.
Lubrication
After every 25 hours of operation grease cylinder and pivot
points with No. 2 multi–purpose lithium base grease. There
are (8) grease fittings at various pivot points and (1) fitting
on each end of cylinder (Fig. 24).
18
Figure 24