Lmi Reported Dlcis Status - Paradyne FrameSaver 9120 User Manual

Displaying System Information

LMI Reported DLCIs Status

4-16
Use this procedure when the FrameSaver access unit is configured as the user
side of LMI (see the frame relay LMI Personality option). Typically, these statuses
are available on the network interface.
Procedure
To display LMI Reported DLCIs Status:
1. Use the following menu sequence:
Main Menu Status
2. Select the desired interface (Network, Port-1, Port-2, BRI-B1, or BRI-B2).
Field
DLCI
Status
CIR (bps)
1
Appears for 10 seconds only, before the network changes Deleted to Inactive
and New to Active.
LMI Reported DLCIs
Status
16 through 1007
Active
Inactive
1
Deleted
1
New
1
0 through 2048000
May 1998
What It Indicates
Identifies the Local Management
Interface-reported DLCI numbers
assigned to the selected interface –
the identifying number assigned to
the path between two frame relay
access unit's ports.
DLCI statuses are listed in
ascending order ( i.e., lowest
number first ).
LMI-reported status of the DLCI:
Whether the DLCI is active
(capable of carrying data) in the
frame relay network,
Whether it is inactive,
Whether it has been deleted by
the frame relay network, or
Whether it has been created by
the frame relay network.
Displays the committed information
rate reported by the Stratacom
switch. CIR information only
appears in this column when
LMI Protocol is set to Standard.
If blank, the switch does not support
this feature.
9121-A2-GB20-20