Wiring - Furuno FSV-30 Installation Manual

2.2 Wiring

Transceiver
Control unit
Control unit
External
monitor
Processor unit clamp
TRANSCEIVER UNIT
FSV-301
*2: Japan Industrial Standard cable
*3: The same type of connector is fitted at each end, however the connector where the amount of sheath
removed is greater should be connected to the transceiver unit.
*4: When running the cables of 10S2078, 10S2223 refer to next page.
*5: When using cable for extension kit, the length of the cable between the transceiver unit
and the hull unit is 5 m or 10 m.
2-2
unit
DPYCYS-2.5 *2
10S2077 (10 m)
*1
PROCESSOR UNIT
DPYCY-1.5 *2
100/110/115/
220/230 VAC
1φ, 50/60 Hz
10S2078 (8 m)
*4 *5
100/110/115/
220/230 VAC
1φ, 50/60 Hz
Wiring
FSV-30
CONTROL UNIT FSV-3001
Monitor
(Local supply)
Monitor cable
(Local supply)
*1: If connector may loosen by
vibration monitor cable may also
be connected inside.
FSV-3002/3002S
*3
220 VAC
3φ, 50/60 Hz
TPYCY-4 *2
HULL UNIT
FSV-303
(1200 mm stroke)
FSV-304
(1600 mm stroke)
10S2223 (14.6 m)
*4 *5