Table of Contents
Advertisement
Mounting procedure
1. Unfasten two bolts from the bottom of the front side of the processor unit. Pull the unit
toward you to separate it from the mounting base.
2. Use six bolts (M6×20, supplied as installation material) to fix the mounting base.
3. Place the processor unit in front of the mounting base.
4. Push the unit forward until it touches the end of the mounting base.
5. Refasten two bolts removed at step 1 to fix the unit to the mounting base.
Front view
1.3 Control Unit
The control unit may be mounted on a tabletop with or without the KB (keyboard) fixing
plate (supplied), which mounts the control unit at an angle. If the control unit is not to be
fixed permanently, lay it atop the rubber feet (supplied as accessories). Be sure to observe
the compass safe distances noted on page ii to prevent interference to a magnetic
compass.
(1) Rubber feet
Attach four rubber feet to the bottom of the control unit if it is not going to be permanently
fixed.
504
5.5
477
34
200+1 195+1
Top view
Processor unit
8
1-9
Hide quick links:
Advertisement
Table of Contents
