Inner Panel Removal / Installation; Finishing Trim Installation - Regency Greenfire GF900C Owners & Installation Manual

INNER PANEL REMOVAL / INSTALLATION

1. Remove front trim piece - see instructions above.
2. Remove two (2) screws to remove to panel clips and release back panel,
lift panel up and out to remove.
3. Remove two (2) screws in locations shown below to release panel clips.
4. Remove 3 screws in locations shown below to remove burner tray.
tooltip
Panel Clip and Burner Tray

FINISHING TRIM INSTALLATION

FINISHING TRIM INSTALLATION
1. Install the finishing trim by lining up trim with the outside of
the fascia. Press trim inward firmly to seat onto the unit.
Note: magnets will keep the trim in place.
tooltip
2. Pull trim outward–away from the unit to remove.
Regency GF900C-2 Gas Fireplace
919-615
Screw Locations
4. Remove panels by sliding out.
5. Reverse steps to reinstall.
Finishing Trim Installed
1
installation
Panel Clip
GF900/GF1500L
11.05.15
43