Table of Contents
Advertisement
installation
GLASS CRYSTALS AND VOLCANIC STONES INSTALLATION ON BURNER AND FIREBOX FLOOR
GLASS CRYSTALS AND VOLCANIC STONES INSTALLATION ON BURNER AND
Spread the Glass Crystals and optional Volcanic Stones evenly over the burner.
For Propane Burners - DO NOT place volcanic stones on burner assembly.
IMPORTANT NOTE:
Only the supplied approved Glass Crystals and Volcanic Stones are to be used with these fireplaces. Use of any other type of glass crystals
or stones can alter the unit's performance, any damage caused by the use of any unapproved glass or stones will not be covered under warranty.
When using Stones DO NOT cover burner ports or pilot light that lead to pilot flame.
For proper flame effect - ensure crystals or stones are spread evenly over the burner.
1. PLACEMENT OF GLASS CRYSTALS:
3) Work Crystals from back to front
edge of Firebox Floor
2. PLACEMENT OF VOLCANIC STONES AROUND BURNER - NG UNIT
Burner Ports
2a. VOLCANIC STONES INSTALLATION AROUND BURNER- PROPANE UNIT
NOTE:
42
919-198
FIREBOX FLOOR
1) Start installing Crystals on the
Burner (NG,Propane,ULPG)
4) Ensure Crystals DO NOT block the
front of the pilot hood and flame to
IMPORTANT: DO NOT COVER BURNER PORTS WITH VOLCANIC STONES
*
Unit is supplied with 32 volcanic stones
NOTE:
Volcanic Stones are NOT to be placed anywhere on the burner ports or Pilot assembly area.
Volcanic Stones are NOT to be placed anywhere on the burner or Pilot assembly area on Propane Units.
Ensure air gap around burner is not obstructed by the placement of the stones.
light the burner
1
GF900C
2) Distribute Crystals evenly starting
from back of Firebox Floor
NOTE: Correct final glass installation of Crystals
shown in step 3 and 4
The Burner and Firebox Floor should not be visible
when the flame is out.
Regency GF900C-2 Gas Fireplace
12.12.17
Advertisement
Table of Contents
