Setting Operation Conditions; Digital Operator Key Description - YASKAWA CIMR-SSA Series Instruction Manual

5

SETTING OPERATION CONDITIONS

5.1

DIGITAL OPERATOR KEY DESCRIPTION

Operation Mode Selection Key
Selects the REMOTE and LOCAL (digital operator)
mode alternately.
Operation Command Keys
Used to operate the inverter by the digital operator.
They are valid only in the drive mode.
JOG: Jog run is possible while JOG key is held pressed.
FWD/REV: Selects forward or reverse run alternately.
RUN: Red LED lights when RUN is depressed.
(Refer to Fig. 27.)
STOP: Red LED lights when STOP is depressed.
(Refer to Fig. 27.)
56
DRIVE FWD REV
DRIVE FWD
DIGITAL OPERATOR
JVOP-132
LOCAL
REMOTE
JOG
FWD
REV
Fig. 26
Digital Operator Key Description
RUN and STOP LEDs light, blink, and go OFF depending on the status of operation.
RUN
Key
Key
STOP
Internal Run
STOP
Command
Speed
Reference
Motor
Reference
RUN LED
STOP LED
:
: Blink
ON
Fig. 27
Run and Stop LED Display
REMOTE
REV
REMOTE
SEQ
SEQ REF
DRIVE
DSPL
PRGM
DATA
ENTER
RESET
RUN STOP
RUN
*
: OFF
* LED goes OFF at flux vector control.
Mode Indicator LEDs
(All LEDs blink if a fault occurs in the drive mode.)
Drive Mode Display
Lights when the drive mode is selected.
OFF when the program mode is selected.
Rotating Direction Display
:
FWD Lights at forward run.
:
REV Lights at reverse run.
Remote Mode Display
Lights in operation mode using the signals input
from the control circuit terminals or option cards.
:
SEQ Lights when the remote mode is selected
for the run command.
REF : Lights when the remote mode is selected
for the frequency reference.
Display
Displays set values of each function or monitoring
values such as speed and output current. (5 char-
acters)
Mode Selection Key
Selects the drive mode and the program mode
alternately. (Mode selection is possible even
during operation.) When the drive mode is se-
lected, DRIVE LED lights.
Display Selection Key
Selects the data to be displayed in predetermined
sequence. (Display sequence is shown in Table 21.)
Read/Write Key
Displays the set values of the constants. Depress-
ing this key again after setting a value enters it.
Numeral Change Key
Changes set values or constant numbers.
: Increment key
: Decrement key
Digit Selection Key
Selects the digit of a set value to be changed.
The selected digit blinks. (This key also
used as the reset key if a fault is displayed.)
STOP