Furuno GP-3500F Operator's Manual page 98

7. NAVIGATION
Navigating a quick route
1. Referring to page 7-1 for the procedure, set SET GO TO METHOD to "2. 35
POINT."
2. Press the [DISP] key, and then select the PLOTTER NAV INFO 1 or PILOT
NAV INFO 1 display.
3. Press the [DISP] key. If the cursor is not displayed, press the [CURSOR
ON/OFF] key to display it.
4. Press the [GOTO] key to show the following window.
5. Operate the trackball to place the cursor on an existing waypoint or a new
location.
6. Press the [ENTER] knob.
When selecting a new location, "QP<01>" appears at the cursor position.
7. Repeat steps 5 and 6 to complete the route.
Maximum 35 points can be entered. To erase last-entered waypoint, press the
[CLEAR] key.
8. After entering all waypoints, press the [ENTER] knob twice.
A light-blue line connects between own ship and the first quick point of the route,
and green lines connect between other quick points. The line shows the shortest
course to destination. Arrows on the line show the direction to follow the route.
Range and bearing from own ship to the first destination appear at the top of
screen. The unit saves the points as a route, under the name "Q<RTE (Quick
Route)."
Note 1: Each time a quick route is entered, previous quick route is written over.
When entering a new quick waypoint, QP<01> is removed from the
Q<RTE.
Note 2: If range and bearing from own ship to the first destination do not appear
on the screen, refer to paragraph 9.6.2.
7-4
Waypoint name appears here.
PRESS KNOB TO SET QUICK POINT IN QUICK ROUTE. PRESS KNOB
TWICE TO START NAVIGATION.
PRESS CLEAR KEY TO DELETE THE PREVIOUS QUICK POINT.
Operation guidance