Using Prog Key - Furuno GP-3500F Operator's Manual

Note: The MOB mark can be deleted as follows.
a) Press the [CURSOR ON/OFF] key to show the cursor.
b) Operate the trackball to place the cursor on the MOB mark.
c) Press the [CLEAR] key.
The following message appears on the screen:
d) Press the [ENTER] knob.
Then, the waypoint entered at step 1 on the previous page is erased.
e) Operate the trackball to place the cursor on the MOB mark.
f) Press the [CLEAR] key.
g) A new message appears on the screen:
ARE YOU SURE?
YES ... PRESS KNOB
NO ... PRESS CLEAR KEY
When MOB is not set as destination
h) Press the [ENTER] knob to erase the MOB mark.
1.7

Using PROG Key

Less-often used functions are provided in the menu. To avoid opening menus to
access a particular function, the [PROG] key may be assigned any of the
function in the menu. Note that the function for [SHIFT], [RANGE], [GAIN] and
[VRM] keys can also be programmed. The default program of the [PROG] key is
as shown in the table below.
•Note 1: To program plotter functions to the [PROG] key ([SHIFT], [RANGE],
[GAIN] or [VRM] keys), see paragraph 9.5.1. For echo sounder functions,
see paragraph 11.16.
Note 2: If the [PROG] key is programmed for a sounder function it may only be
used on the sounder display or a menu entered from the sounder display
only.
WAYPOINT NAME XXXXXX
WILL BE DELETED.
ARE YOU SURE?
YES ... PRESS KNOB
NO ... PRESS CLEAR KEY
Confirmation message
WAYPOINT NAME (MOB)
WILL BE DELETED.
Confirmation message
Key
PROG Displays the WAYPOINT LIST.
1. BASIC OPERATION
THIS WAYPOINT (MOB)
IS USED FOR NAVIGATION.
WILL IT BE DELETED?
YES ... PRESS KNOB
NO ... PRESS CLEAR KEY
When MOB is set as destination
Functions
1-13