Table of Contents
Advertisement
Press
Display Shows
PRINT WIDTH
MAXIMUM LENGTH
46
All manuals and user guides at all-guides.com
Setting Print Width: Press the (+) key to increase the value,
press the (–) key to decrease the value. To change the unit of
measurement, press the (–) key until the unit of measurement is
active, then press the (+) key to toggle to a different unit of
measure (inches, mm, or dots).
Default; Range: The default and range of acceptable values
vary depending on what printer you have. Refer to "Printing
Specifications" on page 86 for further information about the
ranges available for your model.
Print width determines the printable area across the width of the
label.
Setting Maximum Length: Press the (–) key to decrease the
value, press the (+) key to increase the value.
Default; Range: The default and range of acceptable values
vary depending on your printer's configuration. Values are
adjustable in 1" (25.4 mm) increments.
Maximum length is used in conjunction with the calibration
procedure. The value of this setting determines the maximum
label length to be used during the media portion of the calibration
process. Only a few labels are required to set media sensors.
Always set the value that is closest to, but not lower than, the
length of the label you are using. For example, if the length of the
label is 14.5" (368 mm), set the parameter for 15.0" (381 mm).
Bradyprinter 200M-e and 200M-e 300 User's Guide
Action/Explanation
Advertisement
Table of Contents
