Summary Of Parameter Settings - Delta Electronics AC Motor Drive VFD-EL User Manual

Chapter 4 Parameters|

4.1 Summary of Parameter Settings

: The parameter can be set during operation.
Group 0 User Parameters
Parameter Explanation
00.00 Identity Code of the
AC motor drive
00.01 Rated Current
Display of the AC
motor drive
00.02 Parameter Reset
Start-up Display
00.03
Selection
Content of Multi-
00.04
function Display
4-2
Settings
Read-only
Read-only
0: Parameter can be read/written
1: All parameters are read only
8: Keypad lock
9: All parameters are reset to factory settings
(50Hz, 230V/400V or 220V/380V depends on
Pr.00.12)
10: All parameters are reset to factory
settings (60Hz, 220V/440V)
0: Display the frequency command value
(Fxxx)
1: Display the actual output frequency (Hxxx)
2: Display the content of user-defined unit
(Uxxx)
3: Multifunction display, see Pr.00.04
4: FWD/REV command
0: Display the content of user-defined unit
(Uxxx)
1: Display the counter value (c)
2: Display the status of multi-function input
terminals (d)
3: Display DC-BUS voltage (u)
4: Display output voltage (E)
5: Display PID analog feedback signal value
(b) (%)
6: Output power factor angle (n)
Factory
Setting
##
#.#
0
0
0
Revision August 2008, 2ELE, V1.02
Customer