Skoda OCTAVIA Workshop Manual page 80

40
------------ 40-46 ------------
Front Wheel Suspension
Installing
- Press the required grease quantity into the
joint part ⇒ page 40-62; grease quality and
grease quantity
- Insert the cage and hub in the joint body.
Note:
The cage must be inserted in the correct posi-
tion.
- Press in opposite balls one after the other,
during this process observe the prior position
of the ball hub relatively to the ball cage and
to the joint body.
- Insert new circlip in the groove of the shaft.
- Spread any residual grease in the joint boot
⇒ page 40-62
- Assembling the joint boot ⇒ page 40-41 and
further.
Inspecting inner CV joint
Disassemble the joint to replace badly soiled
grease and if the contact surfaces and the balls
must be inspected for wear and damage.
Removing
Note:
The ball hub and joint piece are paired and
must be marked before disassembly. Do not
interchange the bearing track assignment.
- Rotate the ball hub and ball cage.
⊳
- Press the ball hub and ball cage out of the
joint part -arrow-.
- Press out the balls from the cage.
OCTAVIA
Edition 06.05
S00.5103.68.20