Skoda OCTAVIA Workshop Manual page 73

OCTAVIA
9 - Joint boot for inner CV joint
♦ material: Arnitel (Polyelastomere)
♦ inspect for tears and chafing points
♦ fitting location for left shaft ⇒ Fig. 13
♦ fitting location for right shaft
⇒ Fig. 13
♦ assignment ⇒ electronic catalogue of
original parts
10 - Clamp
♦ replace
11 - Cap
♦ remove from CV joint with drift
♦ before assembling coat sealing surface
of cap with sealant D 454 300 A2
♦ sealing surface must be clean and
free of grease
12 - Inner CV joint
♦ must be replaced completely
♦ pressing out ⇒ Fig. 2
♦ pressing on ⇒ Fig. 5
♦ grease ⇒ page 40-62
♦ inspecting ⇒ page 40-46
♦ assignment ⇒ electronic catalogue of
original parts
13 - Circlip
♦ replace
♦ remove with circlip pliers,
e.g. VW 161 A
Edition 06.05
S00.5103.68.20
Front Wheel Suspension
14 - Fillister head screw with internal ser-
ration
♦ replace after each disassembly
♦ initially tighten to 10 Nm, subsequently
♦ assignment ⇒ electronic catalogue of
15 - Shim
♦ assignment ⇒ electronic catalogue of
16 - Gasket
♦ adhesive surface on the inner CV joint
♦ replace
♦ pull off protective foil and stick gasket
♦ assignment ⇒ electronic catalogue of
17 - Cap
♦ remove from CV joint with drift
♦ before assembling coat sealing surface
♦ sealing surface must be clean and
tighten crosswise to final torques
M 8 = 40 Nm
M 10 = 70 Nm
original parts
original parts
must be free of grease and oil!
in the joint
original parts
of cap with sealant D 454 300 A2
free of grease
40
------------ 40-39.2 ------------