Skoda OCTAVIA Workshop Manual page 124

42
Repairing the wheel bearing - Disc brake
Special tools, testers and aids required
♦ Drive bushing MP 3-427
♦ Assembly device MP 5-403
♦ Hub cover puller MP 5-404
♦ Puller Kukko 20/2
♦ Puller Kukko 204/1
1 - Brake disc, internally ventilated
♦ assignment ⇒ electronic catalogue of
original parts
2 - Wheel bolt, 120 Nm
3 - Screw, 4 Nm
------------ 42-28 ------------
Rear Wheel Suspension
4 - Brake disc
♦ assignment ⇒ electronic catalogue of
5 - Cap
♦ replace after each removal
♦ pressing off ⇒ Fig. 1 and 2
♦ inserting ⇒ Fig. 8
6 - Self-locking twelve-point nut, 70 Nm
and tighten a further 40°
♦ replace after each removal
7 - Wheel hub with wheel bearing and
pulse rotor
♦ only on vehicles with ABS
♦ wheel hub and wheel bearing are fit-
♦ the wheel hub and the wheel bearing
♦ replace completely after each re-
♦ Remove wheel hub with wheel bear-
♦ Pull the wheel hub with wheel bearing
Notes:
♦ After pulling off the wheel hub with the
wheel bearing, the inner ring of the bearing
remains on the axle stud, then pull off the
old inner ring of the bearing before pressing
on the new wheel hub with wheel bearing
⇒ Fig. 5.
♦ The inner ring of the bearing is a component
part of the new wheel hub with wheel bearing
and is therefore not pressed on separately.
8 - Axle body
♦ removing and installing
9 - Brake caliper
♦ removing ⇒ Fig. 3.
10 - Axle stud
♦ Straightening work is not allowed!
♦ Re-cutting the thread is not allowed.
original parts
ted together in one housing
are a single unit; it does not need
servicing and is free of play; it is not
possible to undertake any kind of
adjustment or repair work on it
moval
ing from axle stud ⇒ Fig. 4
onto the axle stud ⇒ Fig. 6 and 7
⇒ page 42-12
OCTAVIA
Edition 06.05
S00.5103.68.20