Skoda OCTAVIA Workshop Manual page 48

40
------------ ------------
Front Wheel Suspension
K Pull the inner ring of the bearing off the wheel
hub
- Insert washer MP 6-416 as shown.
- Screw cross member Kukko 18-0 into washer
MP 6-416.
- Install pressure plate MP 3-467 onto wheel
hub and pull off inner ring of bearing by turn-
ing the threaded spindle.
K Press wheel bearing into wheel bearing hous-
ing
A - wheel bearing
- Before pressing in wheel bearing coat evenly
the entire wheel bearing seat in the wheel
bearing housing with G 052 723 A2.
Note:
After pressing in the wheel hub, the circlip must
be inserted ⇒ page 40-17.
K Press wheel hub into wheel bearing
Note:
♦ When pressing in the wheel hub, make sure
the washer MP 6-415 is supported at the in-
ner ring of the bearing.
♦ Observe assignment of wheel hub with wheel
bearing housing and wheel hub for vehicles
with engine as of 110 kW (Brake FN-3)
⇒ Spare Part catalogue.
♦ Wheel hubs with a 3 mm wide ink jet mark
for marking of minimum axial run-out can also
be combined with brake discs without mark-
ing of maximum axial run-out.
The reduction of the entire axial run-out for
Brake FN-3 is then not effective.
OCTAVIA
Edition 04.03
S00.5103.66.20