Skoda OCTAVIA Workshop Manual page 122

42
------------ ------------
Rear Suspension
K Fig. 4 Pulling wheel hub and wheel bear-
ing off axle end
Use a commercially available puller, e.g. Kukko
20/2.
K Fig. 5 Pulling bearing inner race off axle
end
Use a commercially available puller, e.g. Kukko
204/1.
Note:
Do not damage the ABS sensor when pulling
out the bearing inner race.
K Fig. 6 Fitting wheel hub and wheel bear-
ing onto axle end
Use special tool MP 5-403.
- Fit wheel hub and wheel bearing as far as
possible onto axle end.
- Screw on special tool MP 5-403 and pull on
wheel hub and wheel bearing as far as the
stop.
OCTAVIA
Edition 10.98
S00.5103.54.20