Skoda OCTAVIA Workshop Manual page 31

OCTAVIA
4 - 15 Nm and turn through a further 90°
♦ Replace after every disassembly op-
eration
5 - Shift rail
♦ Only for anti-roll bars with a diameter
of 23 mm
♦ Replace with a steel unit
♦ Shift rails on a given axle must be of
the same design
♦ Allocation ⇒ spare parts catalogue
6 - Bearing at the front for the axle guide
♦ Pressing out and pressing in ⇒ Page
40-8
7 - 70 Nm and turn through a further 90°
♦ Replace after every disassembly op-
eration
8 - Rocking pier
9 - 40 Nm and turn through a further 90°
♦ Replace after every disassembly op-
eration
10 - 40 Nm and turn through a further 90°
♦ Replace after every disassembly op-
eration
11 - 20 Nm and turn through a further 90°
♦ Replace after every disassembly op-
eration
12 - Assembly carrier
♦ Removing and installing ⇒ Page
40-10
♦ The undertaking of repairs on the
thread of the front axle guide screw
connection is not allowed!
13 - 15 Nm and turn through a further 90°
♦ Replace after every disassembly op-
eration
14 - Anti-roll bar
♦ The assembly carrier must be lowered
in order to remove and install this
15 - Rubber bearing
16 - 25 Nm
17 - Clamp
Edition 06.02
S00.5103.64.20
Front wheel suspension
18 - Shift rail
♦ Mount the spherical head with the long
♦ Mount the spherical head with the
♦ Allocation ⇒ spare parts catalogue
19 - 90 Nm
♦ Replace after every disassembly op-
20 - Metal - rubber bearing
♦ Pressing out and pressing in ⇒ Page
21 - Nut, self-locking
♦ Replace after every disassembly op-
22 - 100 Nm and turn through a further 90°
♦ Replace after every disassembly op-
23 - Bearing behind for the axle guide
♦ Installed location ⇒ Page 40-9
♦ Pressing out and pressing in ⇒ Page
24 - 100 Nm and turn through a further 90°
♦ Replace after every disassembly op-
25 - 70 Nm and turn through a further 90°
♦ Replace after every disassembly op-
26 - Securing plate
♦ Replace after every disassembly op-
27 - 20 Nm and turn through a further 90°
♦ Replace after every disassembly op-
28 - Axle joint
♦ Checking ⇒ Page 40-19
♦ Check the rubber bellows for damage
♦ Removing and installing only in con-
♦ Mark the installed location before re-
29 - 20 Nm and turn through a further 90°
♦ Replace after every disassembly op-
threaded pin -A- (above) on the spring
plate
short threaded pin -B- (below) on the
anti-roll bar
eration
40-12
eration
eration
40-9
eration
eration
eration
eration
and replace the axle joint as neces-
sary
nection with the wheel bearing hous-
ing ⇒ Page 40-20
moving and place in the middle of the
elongated hole when replacing the
axle guide; also check the tracking
eration
40
------------ ------------