Igniter; Fuel Pipe; Fuel Nozzle - Toyotomi NS-2800 Service Manual

7-3.

Igniter

(1) Remove four (4) screws to remove the front panel.
(2) Remove four (4) screws to remove the igniter.
CAUTION:
When reassembling:
(1) Be sure the end of the igniter is in the proper
position.
(2) Be careful not to tighten screws too tight. The
ceramic may crack.
7-4.

Fuel Pipe

(1) Remove two (2) nuts of the fuel pipe.
(2) Hold the nipple with a wrench and loosen the nut
with another wrench.
Note: It is not necessary to remove the cabinet A.
CAUTION:
When reassembling:
(1) Start the nuts with hand and then tighten them
with a tool.
(2) Be careful of fuel leakage.
7-5.

Fuel Nozzle

(1) Remove the front panel and the cabinet B.
(2) Remove the nut and two (2) screws. Pull the fuel
nozzle out of the burner.
(3) Be careful not to mislay the o-ring and if it is
deteriorated, it should be replaced.
35