Section 7: Disassembly Procedure; Introduction; Cabinet And Panels - Toyotomi NS-2800 Service Manual

7-1.

Introduction

This section shows how to disassemble and reassemble the unit for servicing,
maintenance and repair.
Turn heater off and disconnect the power cord from the battery and allow the heater to
cool down. Then disassemble the heater.
Remove the air ducts, flue pipes and the fuel tube from the unit and dismount the unit
from the hanger by removing the two hexagonal bolts (13mm, 1/2 in.).
CAUTION: Prevent dust or contaminants from being sucked into the fuel pump through
the fuel pump inlet when removing the fuel tube. Otherwise dust can clog the fuel pump.
7-2.

Cabinet and Panels

(a) Front panel:
Remove four (4) screws.
(b) Rear panel:
Remove two (2) screws of
clamps and remove four (4)
screws.
(c) Cabinet B and Bottom panel:
Remove two (2) screws.
(d) Cabinet A:
Remove four (4) screws.

Section 7: Disassembly Procedure

34