Fuel Tank; Solenoid Fuel Pump; Electrical System; Control Circuit Board - Toyotomi NS-2800 Service Manual

Cabin heater

Hide thumbs Also See for NS-2800:

Table of Contents

1-18. Fuel Tank

The tank should contain a fuel strainer and a vent.

The solenoid fuel pump is located on the bottom part of the unit.

All electronic diagrams, such as the wiring diagram, the circuit board layout, and the

electrical schematic can be found in this service manual.

The control circuit board provides safety timings, controls relays and provides thermostat

functions for the cabin heater. A component layout of the printed circuit board is found in

this service manual.

The room temperature sensor, which is capable of sensing room temperature within a

range of 0 to 30°C (32 to 85°F), can be wall mounted.

Approximately 2.5 m (8-1/5 ft.) of wire is supplied with sensor to facilitate wall mounting

in a favorable location.

Several safety mechanisms have been built into the Laser Heating System. These

devices protect the user against personal injury, protect the heater against damage, and

shut down the heater if a malfunction occurs.

When an electric power failure occurs while the heater is in operation, the heater will

automatically re-start after the power is restored.

In the event of a power surge or internal wiring hazards, the fuse will open and power to

the heater will be cut off. The fuse is rated at 10 Amps.

Table of Contents