Indicator Lamps; Weight Transfer Button - Ransomes MP655 Quick Start Manual

QUICK START GUIDE
CONTROLS
ARM REST POD
LIFT/LOWER SWITCH'S
J. Right wing unit
K. Centre three units
L. Left wing unit
To lower the cutting unit move the switch
lever forward.
To raise the cutting unit move the switch
lever rearwards
NOTE:
If the cutter is engaged when the unit is
lowered the green led will illuminate when
the unit is below 400mm from the ground
The yellow PTO LED will illuminate when the
cutter switch in ON. When the blades are
moving the icon on the display change to
green.
If the lever is pulled momentarily rearwards
the unit will raise to the cross cut position
and continue to rotate for 3 seconds.
Lowering the unit within 3 seconds will let
the blade continue rotating without stopping.
If the lever is held and the unit lifts above the
cross cut position the unit will continue to lift
and the blade will stop rotating at 400mm.
The lift will stop when the lever is released.

INDICATOR LAMPS

M Units engaged
N Right wing unit in cutting position.
P Centre three units in cutting position.
R Left wing in cutting position.

WEIGHT TRANSFER BUTTON

This button will transfer weight using the
hydraulic system from the cutting units to the
drive wheels.
en-10
L
K
J
M
N
P
R