Engine Will Not Start - Ransomes MP655 Quick Start Manual

QUICK START GUIDE

ENGINE WILL NOT START

When the ignition key is turned to the start
position this screen is shown. If any of the
following flash.
•The parking brake is not applied.
•The cutter switch is not in the OFF position.
•The foot pedal is not in the Neutral position.
•The operator is not in the seat.
Note. The red LED's either side of the
display will also flash.
The engine will not start until all the items in
the list are correct
WARNING SLOPE ANGLE 16°
0°
During work if the machine is driven on a
slope of 16º the screen will display this
warning. This over rides all other
information, and will continue until the
machine has been driven to an area with a
slope of less than 16º
Press the button below the  to confirm the
fault.
en-14
Slopes > = 16°
in either x or y
VISUAL DISPLAY
WARNING SLOPE ANGLE 19°
0°
If the slope angle reaches 19º the screen will
display this warning which indicates that the
cutting unit arms are locked in the current
position and will continue to run but cannot
be re engaged, until operating below 19°. An
audible warning will be sounded, the warning
will sound four times every 4 seconds and
the red LED's will flash four times every 4
seconds. This will continue until the machine
has been driven to an area with a slope of
less than 19º.
Press the button below the  to confirm the
fault.
WARNING SLOPE ANGLE 25°
0°
If the slope angle reaches 25º the screen will
display this warning indicating that at 25º the
front and centre cutting units will be lifted and
held above the ground to improve the
stability and all cutting units will stop rotation.
An audible warning will be given, the buzzer
will sound four times every 4 seconds and
the red LED's will flash four times every 4
seconds. This will continue until the machine
has been driven to an area with a slope of
less than 19º.
Press the button below the  to confirm the
fault.
Slopes > = 18°
in either x or y
Slopes > = 22°
in either x or y