Table of Contents
Advertisement
Possible cause:
3
The fall sensor has detected a
fall and switched off the engine.
36
Position motorcycle upright
Switch ignition off and then on
again or switch emergency ON/
OFF switch on and then off
again.
Fall sensor defective
VDS! (Vertical Down Sensor) is
z
displayed.
Possible cause:
A defect was determined in the
fall sensor.
Contact an authorized service
facility, preferably an authorized
BMW Motorrad retailer.
ABS self-diagnosis
routine not completed
ABS indicator light flashes.
Possible cause:
ABS self-diagnosis rou-
tine not completed
ABS function is not available
as self-diagnosis has not been
completed. (The motorcycle
must reach a specified mini-
mum speed before the system
can check operation of the
wheel sensors: min 3 mph
(min 5 km/h))
Ride off slowly. It must be
noted that the ABS function
is not available until the self-
diagnosis has been completed.
ABS fault
ABS indicator light lights
up.
Possible cause:
The ABS control unit has de-
tected an error. The ABS func-
tion is not available at all or is
restricted.
It is possible to continue riding
the motorcycle if you make
allowance for the ABS failure.
You should also take account
of the additional information on
situations that can lead to an
ABS fault (
119).
Have the malfunction corrected
as soon as possible at an au-
thorized workshop, preferably
an authorized BMW Motorrad
retailer.
ASC intervention
ASC indicator and warning
light flashes rapidly.
ASC has detected instability at
the rear wheel and responded
by reducing the torque. The in-
dicator and warning light flashes
longer than the ASC intervention
lasts. This feature continues to
furnish the rider with visual feed-
back confirming that the system
has initiated active closed-loop
Advertisement
Table of Contents
