Table of Contents
Advertisement
Disconnect plug connection 1
for high beams.
Rotate the base 2 counter-
clockwise and remove from the
support for high beams.
Replace defective light source.
NOTICE
Light sources featuring spec-
ification ratings for higher lev-
els of illumination are commer-
cially available as special acces-
sories. These light sources have
a shorter service life than con-
ventional light sources and also
generate more heat. Under some
circumstances the high levels of
heat radiation can damage the
headlight assembly.
Bulb for high-beam
headlight
HB3 / 12 V / 60 W
To protect the glass against
soiling, only grasp the light
source by the base.
To secure the light source 1
for high beams, insert the light
source in the support and turn
clockwise.
Connect plug connection 2 for
high beams.
Installing left-hand cover panel
(
160).
Replacing light source for
parking lamps, left
Switch off ignition (
Removing lamp mask (
Loosen the plug connection
from the holder (arrow) (use
a screwdriver if required) and
disconnect from connector 1.
Rotate the socket 2 counter-
clockwise and pull out of the
support.
9
153
45).
159).
z
Advertisement
Table of Contents
