Table of Contents
Advertisement
9
152
Release wire spring 1 from
catch on left and right and fold
up.
Remove light source 2 from
z
socket.
Replace defective light source.
NOTICE
Light sources featuring spec-
ification ratings for higher lev-
els of illumination are commer-
cially available as special acces-
sories. These light sources have
a shorter service life than con-
ventional light sources and also
generate more heat. Under some
circumstances the high levels of
heat radiation can damage the
headlight assembly.
Bulbs for low-beam
headlight
H7 / 12 V / 55 W
To protect the glass against
soiling, only grasp the light
source by the base.
Install light source 1. Start by
inserting the lug 2 then press
the light source into the socket.
Insert wire spring 3 into re-
tainer on left and right.
Connect connector 1.
Install cover.
Installing right-hand cover panel
(
161).
Replacing high-beam
headlight light source
Switch off ignition (
Removing the left-hand cover
panel (
159).
45).
Advertisement
Table of Contents
