Table of Contents
Advertisement
Displaying times
7
98
To display desired time, press
button 1 repeatedly until
display changes.
z
Start time recording
Operate switch 1 to start
recording.
NOTICE
For the headlight flasher signal
to be detected, the engine must
be running and the motorcycle
moving.
When driving over Start/Finish
line, operate switch 1 again to
start recording for next race
lap.
The data of the preceding race
lap will be saved.
If the display mode is exited
during a recording, then the
recording continues to run.
However, in the other display
modes the recording of a new
lap can only be started via an
external signal.
Infrared receiver
with infrared receiver
The lap timer can be conve-
niently operated with an infrared
signal. For this purpose, infrared
receivers available as optional
accessories must be connected
to the IR receiver (on right-hand
side behind side panel). In the
RACETRACK SETUP MENU menu,
a setting can be made to define
whether operation is to be car-
ried out with the headlight flasher
button and TRIP/INFO button
or only with one of the two (see
SETUP MENU chapter).
OA
Advertisement
Table of Contents
