Shipment And On-Site Transport; Accepting The Delivered Goods; Removing The Packaging From The Actuator; Transporting The Actuator - Samson TROVIS 5724-3 Mounting And Operating Instructions

4 Shipment and on-site trans-
port
The work described in this section is only to
be performed by personnel appropriately
qualified to carry out such tasks.
4.1 Accepting the delivered
goods
After receiving the shipment, proceed as fol-
lows:
1. Compare the shipment received with the
delivery note.
2. Check the shipment for transportation
damage. Report any damage to
SAMSON and the forwarding agent (re-
fer to delivery note).
4.2 Removing the packaging
from the actuator
Note
Do not remove the packaging until immedi-
ately before mounting and start-up.
1. Remove the packaging from the electric
actuator.
2. Check scope of delivery (see Fig. 4-1).
3. Dispose of the packaging in accordance
with the valid regulations.
EB 5724 EN

Shipment and on-site transport

1x TROVIS 5724-3 or TROVIS 5725-3
Electric Actuator with Process Controller
1x Document IP 5724
(Important Product Information)
Fig. 4-1: Scope of delivery

4.3 Transporting the actuator

− Protect the electric actuator against exter-
nal influences (e.g. impact).
− Protect the electric actuator against mois-
ture and dirt.
− Observe the permissible transportation
temperature of –20 to +70 °C.

4.4 Lifting the actuator

Due to the low service weight, lifting equip-
ment is not required to lift the electric actua-
tor.

4.5 Storing the actuator

NOTICE
!
Risk of actuator damage due to improper
storage.
Î Observe the storage instructions.
Î Avoid long storage times.
Î Contact SAMSON in case of different
storage conditions or longer storage
times.
4-1